Adjustment and troubleshooting method of clutch control system of truck crane

Nov 22, 2024

Leave a message

Adjustment and troubleshooting method of clutch control system of truck crane

1. Principle of clutch control system

HOYUE series truck crane chassis clutch control system adopts hydraulic control, pneumatic booster structure, its principle is shown in the attached figure. After the driver presses the clutch pedal 1, the master cylinder push rod 2 pushes the piston in the clutch master cylinder 3 downward, and the oil seal of the clutch master cylinder 3 piston closes the oil return hole on the master cylinder wall. The oil in the clutch master cylinder 3 enters the clutch booster cylinder 5 along the pipeline 4, pushes the hydraulic piston to the right, opens the intake valve of the air chamber in the clutch booster cylinder 5, and the compressed air enters the air chamber of the clutch booster cylinder 5. The compressed air pushes the clutch booster cylinder 5 pneumatic piston to move right, the hydraulic piston and the pneumatic piston jointly push the booster cylinder push rod 6 to move right, so that the separation rocker arm 7 rotates counterclockwise, and the separation bearing 8 moves left, so as to realize the clutch separation.

Oil storage tank 9 is used to replenish the clutch master cylinder 3. Clutch master cylinder 3, oil storage tank 9, etc. are arranged in the front of the cab. Oil storage tank 9 is mounted on clutch master cylinder 3 for oil filling.

2. Adjust and exhaust

(1) Clearance between master cylinder push rod and master cylinder piston

Clutch pedal in the free state, clutch master cylinder push rod and clutch master cylinder piston should leave 0.5 ~ 1mm clearance. Check and adjust the method as follows:

Loosen the locking nut of the upper limit bolt of the clutch pedal first, adjust the upper limit bolt to the appropriate position, and finally tighten the locking nut. The clearance between the master cylinder push rod and the clutch master cylinder piston should not exceed 1mm, otherwise it will reduce the effective stroke of the clutch master cylinder and affect the separation effect of the clutch.

Send Inquiry