When the clutch is put down and released, the driver hears the squeaking sound because the clutch separation bearing is damaged, causing the abnormal sound. After the abnormal sound of the clutch is stepped on, the separation bearing is damaged, which will lead to the situation that the vehicle cannot be hung up. The car is mainly replaced in a 4S shop or a maintenance shop in time. The separation bearing is one of the clutch three sets. If the separation bearing is replaced, the pressure plate and friction plate will also be damaged. When the clutch three sets are replaced, all the three sets will be replaced.
What if the clutch squeaks
Step on the clutch ji ji ji rang, the owner can give release bearing grease injection point, if after adding the clutch or in the ring, then release bearing has been damaged, may be a card lag phenomenon or release bearing axial clearance is too large, need to replace the new release bearing, if the wear of the bearing inner ring is larger than 0.3 mm, The whole separation bearing rotates over the separation sleeve, so the bearing and separation sleeve should be replaced.
The three key points of clutch operation are one fast, two slow and three linkage. Is the process of clutch pedal lifting is divided into three stages, at the beginning of the fast lift, when the clutch pressure plate gradually combined with the semi-linkage, the speed of pedal lifting began to slow down, in the semi-linkage to the full combination of the process, the clutch pedal is slowly lifted.
