Hand brake pull still slip car how to do, steep slope hand brake not normal
If on a steep slope, the handbrake pulled also slip the car, this situation is certainly not normal. The reason may be that the handbrake has a virtual position, you can try to tighten the handbrake pull line. Under normal circumstances, we can avoid slipping through the following methods, the operation method is divided into automatic and manual transmission:
Manual gear: can be left foot on clutch and right foot on the brake arbitrary hanging forward block, handbrake, and then flameout, with the traction of the gear to prevent slipping car.
Automatic transmission: step on the brake, put on THE P gear, pull the hand brake, and finally turn off the fire. Use the automatic P gear to lock the gearbox to prevent continued slipping.
If you find that the braking efficiency or sensitivity of the handbrake is not good, you can adjust the operation of the handbrake copper cable to solve the problem. At the bottom of the brake handle and the connection of the copper cable (generally covered by interior ornaments) there is an adjustable compensation mechanism, with a wrench to loosen the locking nut, you can stretch the length of the brake copper cable. However, some car regulation mechanism is located under the car, if the adjustment is not convenient, should be handed over to professional maintenance personnel to deal with.
Encounter slip car, the first time how to operate?
When the vehicle is found to slip the car, should be the first time to use the hand brake or foot brake parking. After parking in the car under the rear wheel cushion triangle wood, stone and so on to start again. If the car brake can not stop, should pay attention to control the direction, avoid the road pedestrians or dangerous targets, and then make the rear of the car towards the roadside natural obstacles close, use them to prevent the vehicle sliding.
